gbyleveldt
AVForums Grandmaster
I'm actually tinkering with the idea of a CNC table myself. I got all the motors already and started some of the hardware / software but again time is my worst enemy. The screws I was using had too high tolerances so now I'm trying to convince my brother to have precision screws turned on the lathe (A little hard if you don't have a CNC lathe!)
Norval, are you going to use Timber's Waveguides or are you going to go the MCM route? I'd like to use Timber's Waveguides, but it seems such a shame to use them if you going to paint over that beautiful wood!
Norval, are you going to use Timber's Waveguides or are you going to go the MCM route? I'd like to use Timber's Waveguides, but it seems such a shame to use them if you going to paint over that beautiful wood!