Den123

I have seen a number of issues using the typical 5.5kVA petrol DIY generator on an inverter. Every time it has been frequency control...

From Christmas to a few days after New Year that stretch of road from Sea Point to Llandudno will take you three hours - one way. Been...

Hi Guys I had to do a job this evening and I realized that my old kit is really getting old. My one signal gen I built from an Everyday...

Then there are those who insist on twisted pairs and screening. Flat ribbons are neither! As Baseline wisely advised - you decide!

Transformers are astonishingly tough. 300VA will suit you well unless you are feeding a large valve amp with a lot of heater overheads...

AndreT: I like my big N/A engines. Mine I modded slightly to keep it 100% drivable on the street, everyday. Idles at 550rpm. However...

Without drawing it out, I would guess some sort of oscillator or signal gen.

6L V8. Instant off-idle torque (just saying....) 😊

Thanks Handsome. That look like a good deal.

You asked for "thoughts", and you are certainly getting them! I also have some thoughts on this - treat them as you should treat all...

I have a story! On my first day at one job, I blew up an expensive spectrum analyser when a wrong ground connection routed power through...

Further to what Shaun was saying, with older 'scopes the "ground" clip was an issue frequently landing up with smoke coming out of the...

Jazzy, looking at the photos you posted, it looks like the input and output are connected on the same terminals, in which case, the...

I suspect most UPS transformers will have a low voltage center-tapped primary. What are you trying to achieve? 230/230V isolation? How...

Aaah! Crafty that! I was wondering when someone would state the necessary !