Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
DIY & Tutorials
DIY For Audio
Transformer position and orientation
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support AVForums:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="ludo" data-source="post: 45240" data-attributes="member: 691"><p>@Handsome. Good points. I'm open to the possibility that EI or C-core might be better in practice. What tickles me is the non-symmetric nature of the field around the toroid. I'm not sure if, if the field could be kept symmetrical, it will of necessity be smaller. Or whether the oddity that causes the non-symmetry, is actually helping us by creating a quiet spot. Times like these when I wish I had an education in these things.</p><p></p><p>If it is possible to get a very quiet setup without resorting to strangely shaped winding wire, that would be neat. Especially if a manufacturing process that is apparently guarded as a trade secret, is actually something quite simple.</p><p></p><p>@Ampdog. The sketch is pretty much what I had on the table. Having to twist these things in the past to get amps quiet, I never got the idea that the output wires' positions was the issue. No two are quite the same. I'll fiddle with it some more. Lots of things to try still.</p></blockquote><p></p>
[QUOTE="ludo, post: 45240, member: 691"] @Handsome. Good points. I'm open to the possibility that EI or C-core might be better in practice. What tickles me is the non-symmetric nature of the field around the toroid. I'm not sure if, if the field could be kept symmetrical, it will of necessity be smaller. Or whether the oddity that causes the non-symmetry, is actually helping us by creating a quiet spot. Times like these when I wish I had an education in these things. If it is possible to get a very quiet setup without resorting to strangely shaped winding wire, that would be neat. Especially if a manufacturing process that is apparently guarded as a trade secret, is actually something quite simple. @Ampdog. The sketch is pretty much what I had on the table. Having to twist these things in the past to get amps quiet, I never got the idea that the output wires' positions was the issue. No two are quite the same. I'll fiddle with it some more. Lots of things to try still. [/QUOTE]
Insert quotes…
Verification
Post reply
DIY & Tutorials
DIY For Audio
Transformer position and orientation
Top