Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
DIY & Tutorials
DIY For Audio
Speaker port position.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support AVForums:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Norval" data-source="post: 35472" data-attributes="member: 62"><p>A wave guide increase the sensitivity at the lower end of the tweeters response without increasing distortion. If you then EQ the response curve to be flat, the equilization also push the distortion levels down.</p><p></p><p>EQ can be done by a cap and resistor in parrallel with each other and in series with the tweeter. But Zaph has done this by using a single cap of correct value, which then acts as EQ and provides a nice 2nd order LF cut off. Check out his web page</p><p></p><p>http://www.zaphaudio.com/hornconversion.html</p></blockquote><p></p>
[QUOTE="Norval, post: 35472, member: 62"] A wave guide increase the sensitivity at the lower end of the tweeters response without increasing distortion. If you then EQ the response curve to be flat, the equilization also push the distortion levels down. EQ can be done by a cap and resistor in parrallel with each other and in series with the tweeter. But Zaph has done this by using a single cap of correct value, which then acts as EQ and provides a nice 2nd order LF cut off. Check out his web page http://www.zaphaudio.com/hornconversion.html [/QUOTE]
Insert quotes…
Verification
Post reply
DIY & Tutorials
DIY For Audio
Speaker port position.
Top