Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
DIY & Tutorials
DIY For Audio
crossover components and design
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support AVForums:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="JimGore" data-source="post: 61576" data-attributes="member: 3"><p>Hi Byron,</p><p></p><p>I have imported 20 each red and black binding posts as well as the spikes. I think the pics of the binding posts are earlier in this thread together with the spikes. I also have about 10x each red and black Bennic binding posts here at home, so we should have more than enough.</p><p></p><p></p><p>I have the following sizes: 1.0, 2.0, 3.3, 4.7, 6.8, 7.5, 8.2, 10, 12, 15, 18, 20, 30 ohms. I also have 6x L-Pads, so I think we are covered.</p><p></p><p></p><p>I have taken this into consideration with the parts lising in the ZRT thread. There is very little difference in DCR between the 2.2 and 2.7 mH inductors - it is a matter of half a bobbin worth of turns, so you will not need to change the resistor when changing the BSC on the coil.</p><p></p><p>Regards,</p><p>Ian.</p></blockquote><p></p>
[QUOTE="JimGore, post: 61576, member: 3"] Hi Byron, I have imported 20 each red and black binding posts as well as the spikes. I think the pics of the binding posts are earlier in this thread together with the spikes. I also have about 10x each red and black Bennic binding posts here at home, so we should have more than enough. I have the following sizes: 1.0, 2.0, 3.3, 4.7, 6.8, 7.5, 8.2, 10, 12, 15, 18, 20, 30 ohms. I also have 6x L-Pads, so I think we are covered. I have taken this into consideration with the parts lising in the ZRT thread. There is very little difference in DCR between the 2.2 and 2.7 mH inductors - it is a matter of half a bobbin worth of turns, so you will not need to change the resistor when changing the BSC on the coil. Regards, Ian. [/QUOTE]
Insert quotes…
Verification
Post reply
DIY & Tutorials
DIY For Audio
crossover components and design
Top