Search results

I made two other cuts in stainless steel. I got the brass cuts because I was not sure about the magnetic properties of the stainless steel since a magnet goes behind one of them and that triggers a reed relay. This cut was used to cover a keyhole.

I received the order and everything was in order. Can recommend Metal Centre

Thanks, I will check them out.

Linden JHB

Hello, I am aware for the replacement bulbs that were available from Mantec for the old Fuse Light Bulbs, But I am sick of these things dying so, I will put some LEDs there instead. Can anyone recommend what LED wavelength should be used in the Marantz Models ? I was thinking of Yellow or...

Hello Everybody, Could anyone direct me where to buy one of the lamp shades seen in the photo below Byron

I'm thinking of implementing one of these...

I filled out an order with Metal Centre. I took brass instead of ABS. I'll update once I have received the order Byron

Hello everybody, I need to get some stainless steel and ABS laser cut or CNCed, I need a disc cut with a diameter of 45mm and a rectangle [45x180 mm], so the needed cuts are not that big. Both materials need to be 2 [mm] thick. Could anyone recommend a company that could do this for me ? I...

I was worried about that but supporting the new sheet without connecting it to the other sheet of wood would require drilling into the wall which was not an option. The sound insulation is still more than adequate.

Hello Everybody, For the past 2 years, the soundproofing has been working quite well. But two issues came up. 1: This foam is quite ugly, the black foam would probably look cool but ill not waste my money on that. 2: The Wifi reception in my room sucks. So My plan was 1: Place another sheet...

### UPDATE ### So Universty has been hectic and caused this project to slow down but I have now completed it ! So the story goes. I bought a new Bed after moving into the new apartment, I was then about to throw away my old mattress when I thought "Maybe I can just push this in the door frame...

Here Is some update drawings done in Google Sketch Up

I did just notice this on the Isover cover it s also pretty cheap... I just read that polystyrene is not a good option for sound proofing. Any other suggestions on how to seal the wood within the door frame ?

I cannot stick anything to the wall. duct tape will remove the paint eventually.

Could you please explain "get on the job with the wooden piece in its natural state" ? I cannot tell if its an innuendo. Here is a super rough drawing of my plan. Note in the drawing the noodles are only on two sides but the plan is to surround the wood with them. Ill cut the "noodle"...

Gentlemen, one at a time. It depends hey, not everyone is into that  :roll: Im not aiming for ones with moustaches here  :whistler: I can always rely on Steerpike for good advice ! So I have two plans of actions here. [list type=decimal] Try put a seal on the door with some of this. I...

Gentlemen ! Here is the Door in question. Here is the amount of depth we can work with roughly 48 cm. Ill post more text tomorrow its a bit late now, Cheers for all the feedback though. Regards Byron

:ROFLMAO: HiFi and any other noise coming from that room. That door needs to be sound proof both ways. but I would say Soprano.  :thinking: Ill post a picture of the frame tomorrow morning.