crossover design

[KKAN]

Hey guys

How do I design a cross over with limited available specs for the drivers? I have acquired drivers that came off the mission m6ci center and plan on building 2 little
 2way bookshelf's

[Curlycat]

I am not sure what you are going to do as far as box design is concerned without the speaker parameters.
This site is quite helpful for XO design. https://www.diyaudioandvideo.com/Tutorial/DesignBuildCrossover/

I see the frequency response is 65 - 20,000Hz, but that will include the tweeter.
http://www.superfi.co.uk/p-7109-discontinued-mission-m6ci-centre-speaker-black.aspx
https://www.hifix.co.uk/mission-m6ci-centre-speaker

   
Frequency Response at 3dB 65Hz to 20kHz
Sensitivity SPL/m/2.83V 87dB
Amplifier Power Range 25 to 100 watts
Dimensions (HxWxD) in mm 178x480x251
Cross Over Frequency 2.4kHz
Effective Volume 8.7 litres
In room frequency bandwidth -6dB at 60Hz to 28kHz
Enclosure Type 2 way reflex loaded
Nominal Impedance 8 ohm (minimum3.8 ohms)

[KKAN]

Hey curlycat thanks, yep that's about what I found as well, very new to diy, so trying to figure what I can do with this information.

Also not exactly sure what to do with the box

[bbe22]

http://techtalk.parts-express.com/forum/tech-talk-forum/38661-the-speaker-building-bible       be patient a lot of info here

the easier  but correct way out would be to find a forum member that can measure and design a proper X-over and box for those drivers, and where you will be using them,  and then you build it out   

[KKAN]

the easier  but correct way out would be to find a forum member that can measure and design a proper X-over and box for those drivers, and where you will be using them,  and then you build it out   

 

I'm in PMB, so if anyone is in KZN with the know how regarding this i'd like to visit 

Els im just going to wing it