CNC - and you thought DIY is a bottomless pit eh?

AVForums

Help Support AVForums:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

gbyleveldt

AVForums Grandmaster
Joined
Jul 9, 2006
Messages
8,796
Reaction score
5
Location
Benoni
I'm actually tinkering with the idea of a CNC table myself. I got all the motors already and started some of the hardware / software but again time is my worst enemy. The screws I was using had too high tolerances so now I'm trying to convince my brother to have precision screws turned on the lathe (A little hard if you don't have a CNC lathe!)

Norval, are you going to use Timber's Waveguides or are you going to go the MCM route? I'd like to use Timber's Waveguides, but it seems such a shame to use them if you going to paint over that beautiful wood!
 
Top