Hi all
I'm still doing the planning/research for my intended build over December. I'm just curious to find out a few things....
1. Which method you guys prefer for doing your driver holes.
Cutting the bigger diameter recess line first, then follwed by the smaller circle for the driver to fit through
or
Cutting the smaller circle first followed by a rabbeting bit to make the bigger recess line
2. Veneer.... where to get it in JHB (or pta) in small sizes (not 3m x 2m sheets)
3. Veneer 1st and then route or the other way 'round ?
Thanks!
I'm still doing the planning/research for my intended build over December. I'm just curious to find out a few things....
1. Which method you guys prefer for doing your driver holes.
Cutting the bigger diameter recess line first, then follwed by the smaller circle for the driver to fit through
or
Cutting the smaller circle first followed by a rabbeting bit to make the bigger recess line
2. Veneer.... where to get it in JHB (or pta) in small sizes (not 3m x 2m sheets)
3. Veneer 1st and then route or the other way 'round ?
Thanks!