Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
DIY & Tutorials
DIY For Audio
December build
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support AVForums:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="bbe22" data-source="post: 1129190" data-attributes="member: 863"><p>- assuming the TC8 is a 8 ohm driver . If you try my suggestion as above , the correct starting point for the full range would be a 33uF in series with the driver and a 1.0 mH inductor in parallel. (2nd order high pass @ 1K) After the 33 in series you might need to add a a resistor to balance the response between bass and fullrange . Again you can experiment with 22uF and 47 uF in the cap values also , (lower cap value moves up the Xover point....)</p></blockquote><p></p>
[QUOTE="bbe22, post: 1129190, member: 863"] - assuming the TC8 is a 8 ohm driver . If you try my suggestion as above , the correct starting point for the full range would be a 33uF in series with the driver and a 1.0 mH inductor in parallel. (2nd order high pass @ 1K) After the 33 in series you might need to add a a resistor to balance the response between bass and fullrange . Again you can experiment with 22uF and 47 uF in the cap values also , (lower cap value moves up the Xover point....) [/QUOTE]
Insert quotes…
Verification
Post reply
DIY & Tutorials
DIY For Audio
December build
Top